Author Topic: EaglePicher PMG 200a @ 48v wiring ... Pinging Mobile Bob ....  (Read 598 times)


  • Jr. Member
  • **
  • Posts: 66
    • View Profile
EaglePicher PMG 200a @ 48v wiring ... Pinging Mobile Bob ....
« on: September 11, 2023, 07:57:07 PM »
So I picked up two of these units many years ago. Apparently they're from a telecom unit that had two running together in parallel for 400a @ 48v hooked up to a NG engine. Not sure if it was spec's at 1800 rpm or 3600 rpm. There is some information on the Micro Go gen forum but the site seems to be down. At least you can't get into any sub forms.

Anyway apparently these are rated for 48v @ 200a each. I'm really just in the testing phase but I haven't a clue as to how to wire these up and there is ZERO information about them online. I gather as most units like these utilize 3 phase AC output, my intention is to rectify the output to DC and run that into a charge controller/inverter.  Any help would be appreciated.

Thank you.
« Last Edit: September 11, 2023, 08:30:06 PM by RJ »