Lister Engines > Original Lister Cs Engines
Lister CS 12-2 rebuild
ajaffa1:
Hi Black Dog, next time you post something, have a look for the Attachments and other options button, just below where you type your message. Click on the button and it will allow you add pictures and pdf documents. There is a limit on how big the data is, I had to turn down the resolution on my camera.
How bad are the big end crank journals? Are you planning to put this engine to work or take it to a show or two? The big end bearing caps have small shims that can be removed to allow for some amount of wear in the crankshaft, a new set of bearing shells might be adequate.
Bob
Black Dog:
I tried attaching two photos. The big end would be OK with new shells but the center main bearing and the # 1 main bearing are bad. Not planning of putting her into work but if going to rebuild I think I should do a "proper" job.
Black Dog:
Second photo
sirpedrosa:
Hi BD
FWIW you can see my thread here, onwards: https://listerengine.com/smf/index.php?topic=8320.msg100396#msg100396
Burned babit is always an issue, but nothing that cant be fixed.
Take care.
VP
38ac:
Thanks Bob,
Yes I have all nornally used CS and India clone parts and quite a few not so normally used. Beside standard sizes I also stock oversize pistons and undersized big end bearings. Center mains for the twins are in standard size are on my current order due to ship soon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version