Author Topic: Pushrods (Read 1158 times)

Brad Silwood · « **on:** November 02, 2021, 03:43:26 AM »

I was negligent in labeling, for different length pushrods. Which length goes on which side. Thanks guys

veggie · « **Reply #1 on:** November 02, 2021, 02:06:27 PM »

Strange, on my engine the push rods are the same length.

Brad Silwood · « **Reply #2 on:** November 02, 2021, 08:23:28 PM »

Thanks Veggie, yea, I "assumed" mine would have been also. One is 3/8 inch longer than the other. $:-\$

38ac · « **Reply #3 on:** November 02, 2021, 11:50:38 PM »

The long one goes on the intake valve. Look at the lifters, the exhaust lifter is taller due to the compression release.

mike90045 · « **Reply #4 on:** November 03, 2021, 04:49:37 AM »

I put a zip-tie on the far side ( exhaust ) pushrod, makes it easier to see it spinning around. And mine are not the same length either.

Brad Silwood · « **Reply #5 on:** November 03, 2021, 06:06:45 AM »

The long one goes on the intake valve. Look at the lifters, the exhaust lifter is taller due to the compression release.

Yep, makes perfect sense. Thank you

News: