General Category > General Discussion
Welding from a Listeroid/ST generator rig
Martin:
In this picture the crank is at 9 o'clock when viewed from the front of the engine. So looking in through the crank case door gives a view of the bottom of the two kidney shaped counterweights.
Martin:
This is a view through the crank case door with the crank at TDC, so we can see the sides of the two counter weights.
Martin:
This one shows the crank at TDC, but the picture is taken at an oblique angle to show the kidney shaped profile of the counter weights.
Martin:
Crank at BDC showing the counter weights at the top.
38ac:
Martin, that type flywheel was used on the internally balanced engines with counter weights on the crankshaft. That flywheel should sit still on a balance stand in any position.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version