Lister Engines > Original Lister Cs Engines
Lister CS 3.5
(1/1)
littleridge:
Hello Members
What is the correct ring gap for new parts ,Rings and liner.
thanks.
38ac:
It is not mentioned in the technical specifications but in my 6/1 manual the minimum end gap is .012". A 3/1 would be slightly less due to smaller bore. I would go with .010" Be sure to check the side gap in the top groove as they take a beating. restoring side gap is far more important than end gap as for restoring compression.
littleridge:
Thanks 38ac,I was on the same lines.
Navigation
[0] Message Index
Go to full version