Puppeteer

Author Topic: DIY Silicon gaskets and fuel lines  (Read 1846 times)

snowman18

  • Full Member
  • ***
  • Posts: 216
    • View Profile
DIY Silicon gaskets and fuel lines
« on: March 13, 2020, 02:04:35 AM »
I'm re-purposing an old 5 gallon Webster Pressurized paint pot into an autoclave, over the years the lid gasket has stiffened up and needs to be replaced.

The pot used as an autoclave operates at a much lower pressure than it had as a paint pot, 15 psi max. I've decided to make my own gasket from high temp silicon.

On my quest for knowledge the first YT video blew me away, this guy shows how to make silicon fuel line. I was not aware that hydrogen peroxide would act as a curing agent.

The pot I have is much older than the one below and has more lid clamps.


https://youtu.be/KlNXHEqKLdg
\


snowman18

  • Full Member
  • ***
  • Posts: 216
    • View Profile
Re: DIY Silicon gaskets and fuel lines
« Reply #1 on: March 14, 2020, 05:30:58 AM »

BTW, for your pressure pot I'd actually look at the polyurethane sealers like the stuff that comes in Sausages for the building game.
That stuff is way more flexible and tougher than silicone would makes excellent sealer and gaskets.  Used some the other week on a carby bowl with a hard seal and it hasn't leaked since.

Polyurethane will not hold up, water at 15 atmospheres makes steam at 250 F.

EdDee

  • Hero Member
  • *****
  • Posts: 773
    • View Profile
Re: DIY Silicon gaskets and fuel lines
« Reply #2 on: March 24, 2020, 10:50:14 AM »
Long length of DIY o-ring stock of suitable sectional diameter and a tube of crazy glue.....?
12/1 750RPM/9HP Roid 5kVA- WMO Disposal/Electricity & Hot Water Gen
12/1 650RPM/8HP Roid 4.5kVa - Demon Dino
Chinese Yanmar - Silent Runner with AutoStart
Classic Komatsu 1963 Dozer/Fergusson 35 Gold Belly ...
Bikes,Cars,Gunsmithing & Paintball...Oh yes, a 5Ha open air Workshop to play in!