2 kW generator head

[guest23837]

Then there is this method that was mentioned here on LEF in a different thread. Looks like an inexpensive way to go.
https://www.youtube.com/watch?v=Se6ceGegUYQ

Also this http://www.utterpower.com/a-free-diyer-generator-head/

Worth a look anyway!
Cheers,
Hugh

I saw this a few months ago and I actually checked and you can buy a 4 bolt pillow bearing that lines up perfectly with the holes in the alternator end casing The bearing should be the same size as the shaft too . A taper lock pulley and Robert's your mothers brother

[Hugh Conway]

Johndoh, might you have a contact for that adapter?
Good information to have!
Cheers,
Hugh

[guest23837]

Johndoh, might you have a contact for that adapter?
Good information to have!
Cheers,
Hugh

It's just a standard pillow block bearing if you're in the UK you can buy imperial or metric sizes.

https://www.ebay.co.uk/itm/UCF204-20mm-Mounted-Bearings-4-Bolt-Square-Flange-Pillow-Block-Bearing-Housing/122687376627?var=&hash=item1c90bcccf3

[ajaffa1]

Mr Hanglands is a very useful mammal. Love his outside the box thinking.

Bob