Author Topic: 2 kW generator head  (Read 6015 times)

guest23837

  • Guest
Re: 2 kW generator head
« Reply #15 on: June 03, 2018, 07:44:58 PM »
Then there is this method that was mentioned here on LEF in a different thread. Looks like an inexpensive way to go.
https://www.youtube.com/watch?v=Se6ceGegUYQ

Also this http://www.utterpower.com/a-free-diyer-generator-head/

Worth a look anyway!
Cheers,
Hugh

I saw this a few months ago and I actually checked and you can buy a 4 bolt pillow bearing that lines up perfectly with the holes in the alternator end casing The bearing should be the same size as the shaft too . A taper lock pulley and Robert's your mothers brother

Hugh Conway

  • Hero Member
  • *****
  • Posts: 529
    • View Profile
Re: 2 kW generator head
« Reply #16 on: June 03, 2018, 09:45:46 PM »
Johndoh, might you have a contact for that adapter?
Good information to have!
Cheers,
Hugh
JKson 6/1  (Utterpower PMG ) Off-grid
Lister 6/1 Start-O-Matic engine......running with PMG
1978 Royal Enfield (glutton for punishment by Indian iron)
1963 BMW R-27 project

guest23837

  • Guest
Re: 2 kW generator head
« Reply #17 on: June 03, 2018, 09:53:11 PM »
Johndoh, might you have a contact for that adapter?
Good information to have!
Cheers,
Hugh

It's just a standard pillow block bearing if you're in the UK you can buy imperial or metric sizes.

https://www.ebay.co.uk/itm/UCF204-20mm-Mounted-Bearings-4-Bolt-Square-Flange-Pillow-Block-Bearing-Housing/122687376627?var=&hash=item1c90bcccf3

ajaffa1

  • Hero Member
  • *****
  • Posts: 1725
    • View Profile
Re: 2 kW generator head
« Reply #18 on: June 03, 2018, 10:53:20 PM »
Mr Hanglands is a very useful mammal. Love his outside the box thinking.

Bob