Puppeteer

Author Topic: Listeroid 6-1  (Read 4279 times)

2ringers6

  • Newbie
  • *
  • Posts: 25
    • View Profile
Listeroid 6-1
« on: January 01, 2015, 04:25:50 PM »
It seems as I always have too many projects and too little time. 
I have a 6-1 built in the summer of 2013 from DES.  It was thoroughly cleaned and sealed.  It was only run for minutes to fine tune the balance.  It has not been run to break it in yet.  It is balanced very well.  It will run just on 2 4x4's sitting on the garage floor.  I have an upgraded fuel filter installed.  I also have a new ST-5 from CGG and I have the pulley for the generator head.  I also have a 12 volt starter from one of the members.  I also have a gib key puller as well as a glow plug (not installed).  All that is needed to compete is a radiator and hoses and a belt.  This would be an excellent engine for on a cart since it is balanced so well.

I am selling everything together.  I will not part it out, because if it doesn't sell, I will eventually finish it.

$3640.00 cash only, picked up only.
I have an engine hoist and could load into a low trailer.

Located in Central Pennsylvania.

The following video's are of this engine running fastened to 2 4x4's which are just sitting on a concrete floor.

https://www.youtube.com/watch?v=Bn8Pq4SDVZs&list=UUR5R6Ly3zgTNmw7KZmHbvQA

https://www.youtube.com/watch?v=90yYuQS9tuk&list=UUR5R6Ly3zgTNmw7KZmHbvQA

tyssniffen

  • Full Member
  • ***
  • Posts: 178
    • View Profile
Re: Listeroid 6-1
« Reply #1 on: January 01, 2015, 05:02:48 PM »
your vids seem to be set to private on youtube. can't view.
6/1 with 2 tank for WVO.  pushing power into off-grid house battery bank, in winter.

PaperPatched

  • Newbie
  • *
  • Posts: 15
    • View Profile
Re: Listeroid 6-1
« Reply #2 on: January 01, 2015, 05:35:34 PM »
Same here. Can't view the video.

2ringers6

  • Newbie
  • *
  • Posts: 25
    • View Profile
Re: Listeroid 6-1
« Reply #3 on: January 01, 2015, 06:05:52 PM »
They should be viewable now.

I didn't know there was a private setting.