« previous next »
Pages: [1]

Author Topic: Parts for a SCTF117 BRUSH generator.  (Read 4351 times)

philpods

  • Newbie
  • *
  • Posts: 2
    • View Profile
Parts for a SCTF117 BRUSH generator.
« on: February 05, 2014, 10:01:49 AM »
Hi,
I have recently obtained an ST1 with a Brush generator.  It is however missing the arms and brushes which sit on one of the slip rings.  Try as I might, I have been unable to locate someone who might be able to supply parts for this.  Can anyone assist and point me in the right direction.

Thanks,

Phil.
Logged

Bottleveg

  • Full Member
  • ***
  • Posts: 246
    • View Profile
Re: Parts for a SCTF117 BRUSH generator.
« Reply #1 on: February 05, 2014, 10:59:54 AM »
I have a selection of slip ring arms so may have them.
I’ll need a photo and some measurements. PM me your email and I’ll get in touch.
   Mark.
Logged

philpods

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Parts for a SCTF117 BRUSH generator.
« Reply #2 on: February 05, 2014, 12:11:51 PM »
Here are a couple of pics, one from each side.





Unfortunately someone has had a go at it prior to me getting hold of it and hasnt put things back where they belong.  :'(
Logged

Kernowman

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: Parts for a SCTF117 BRUSH generator.
« Reply #3 on: April 03, 2014, 07:37:44 PM »
Hi Phil,

I've just got some parts for my SCAF 2.25 from ECCGenSpares (who took over the Brush spares stock for the small generators from Brush themselves). Very good value & their technical chap, Bill Ward, is very helpful. Would thoroughly recommend them.

All the best,

Kernowman.
Logged
Pages: [1]
« previous next »