Author Topic: bryce pump woes  (Read 3253 times)

cylinderheadnut

  • Newbie
  • *
  • Posts: 48
    • View Profile
bryce pump woes
« on: December 13, 2013, 09:36:30 PM »
Hi all,

 i have a Bryce Berger fuel pump on a Petter PJW, i had to remove it and re tap the bleed screw threads, my manual says the rack should have a calibration mark on it, mine doesn't, so where do i measure the setting from ?

millman56

  • Sr. Member
  • ****
  • Posts: 393
    • View Profile
Re: bryce pump woes
« Reply #1 on: December 13, 2013, 10:26:32 PM »
Hi,   
What setting?

Mark.

cylinderheadnut

  • Newbie
  • *
  • Posts: 48
    • View Profile
Re: bryce pump woes
« Reply #2 on: December 13, 2013, 11:01:08 PM »
when i put the linkage back i need to measure 20.6 mm from the pump body to this mark.

dieselgman

  • Hero Member
  • *****
  • Posts: 3189
    • View Profile
    • Lister Parts
Re: bryce pump woes
« Reply #3 on: December 14, 2013, 01:49:26 AM »
I have seen the Bryce pump cross-shafts both with and without the alignment mark. I do not have the specifics for the PJW but I would think there would be another pump around somewhere to use as a guide.
It is generally only the multi-cylinder engines where the marks become critical for proper adjustments though.

dieselgman
ALL Things Lister/Petter - Americas
Lyons Kansas warehousing and rebuild operations