Alternative fuels > Straight Vegetable Oil

Nextera canola oil

<< < (2/2)

rcavictim:
Here is the DIY injector heater for my JD175A.  The spacing between the two injector hold down studs on the head was just a bit too narrow to clear my fragile ceramic beads and many got broken during the installation.  It still works fine however.  The wire is about #14 gauge diameter and is salvaged from a high power motor start resistor.  Due to the heat it is imperative to terminate the ends in a solderless, bolted connection.

 

Navigation

[0] Message Index

[*] Previous page