Listeroid parts?

[zacksstacks]

OK, so now I've got my Power Line 10/1 and it's apart - mostly. So far, it's proven to be pretty much like they say - reasonably nice outside, very gritty inside. It sat for a couple of years so there is some surface rust in the cylinder  hopefully that will hone out. But with so much grit inside, I think I'd best be replacing the bearings including the TRBs.

Does anyone have a US part # for the TRBs, or is that a take-it-to-the-bearing-shop deal?

Also, is there a US source for gaskets and/or other parts for the 10/1? I think it has a 4.75" bore...

And, is there someone with a gibb key remover available now? Mike Montieth's out of stock. 

[Tom]

George B. at utterpower.com should have the parts.

[zacksstacks]

Whoops: my mistake. What I initially took for grit was surface rust on the con-rod. After disassemby, it's not looking so bad! I've had to flex-hone the liner, there was standing water in the cylinder apparently, but it seemed to clean up mostly. I'll be putting it back together soon and hope for the best!

Wish I had a camera able to take decent pics!