How to / DIY > Engines

Machine Drawings of Lister?

(1/2) > >>

evilpsych:
Hey guys.. are there open-source plans for the lister? I think it would be pretty neat if someone here in the US was able to refine the lister down, and make their own hobby castings. There's a lot of fellows playing around with home cast-iron foundries.

MeanListerGreen:
We have CMM (coordinate measeument machine) at work and I havebeen trying get the operator to measure all the machined surfaces of a case.  That would be a big help.

dkwflight:
Hi from some of the comments here you would realy need to measure several and average, maybe?
Dennis

evilpsych:
i dont know.. perhaps it would be enough to know all of the specs of the engine, so you could get a custom-ground cam, and crankshaft along with a head. Just think of how long a precision version of a lister would run? Of all of the horror stories about shaft-holes drilled off center or off-90deg, i'm a little hesitant to buy a indian lister.

1966Crew:
I was over at Smokestack.com and ran accross John Burnes post about some 4hp Reid bedplate paterns he had made. Could be done with a Lister too!

I asked him about his project and he gave some insight but he will not know the whole cost of the project until all is said and done.

Here is the link: http://www.smokstak.com/forum/showthread.php?t=34500

Very interesting.
Jon

Navigation

[0] Message Index

[#] Next page