After much searching ( about 15 minuts worth in the bone yard ) I've decided I should make a fuel tank for Gus.
Then I read a post on SmokeStak about a fellow that made a reproduction Steel tank and soldered it.
I assume he used a much higher tin alloy than I'm used to using. The Silver is no good ( at least the stuff I used in the motor shop too much heat needed ) so what kind of solder is right for joining a steel tank, and what kinf of acid flux is best. How big of an Iron do I need and or should I try electric or copper heated by torch ect...
Way out there with this post I know, I'm on a "If I can't make it Gus don't need it kick"....
Educate me fellow motor heads!!!
Here is a link to the fellow that made his
http://www.smokstak.com/forum/showthread.php?t=36013&highlight=made+tankDoug