Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - schoust

Pages: [1]
1
Listeroid Engines / 12-1 Thermostat #'s
« on: February 24, 2007, 08:56:31 PM »
      Guy's I'm looking at putting a thermostat in my 12-1 Listeroid made by Power Annan (Powerline) I was wondering if any of you guy's have the of the shelf model numbers??

2
Listeroid Engines / Oil pump issues??
« on: January 21, 2007, 09:57:57 PM »
 Ok Guy's I have started to prep my Ananon 12-1 for starting I filled the crank case with oil and went to prime the oil pump via the hand pump and could not get it to move?? Has anyone had this problem with there pump?? I'm thinking maybe it has some sort of bur in the cylinder thats causing the pisten to hang up??

3
Lister Based Generators / Themosiphone Limits
« on: January 11, 2007, 01:18:52 PM »
   Ok Guy's I have been thinking about how I'm going to set up my Listeroid gen set cooling loop and what I have come up with Is a couple of unit heaters with electric fans that were being demoed out on a job I am on so what I was thinking I would hang one in the garage and one in a space where i could dump heat,my question is what are the limitations On the height that this type of cooling will work? At what point will a pump need to be used???

4
Listeroid Engines / Unground Muffler design
« on: May 11, 2006, 02:20:27 PM »
   I'm thinking about rynning my exhaust under ground into a barrel,has anyone designed this sort of exhaust setup??

5
Listeroid Engines / Spare Parts
« on: May 06, 2006, 08:19:41 PM »
    I will be picking up a 12-1 for a Net Metering/cogen operation that will be running on Vegi and or Bio Diesel.I will be running the machine as much as possible so I was wondering what spare parts I should get?Anyone with extensive run time care to opine.......

6
Listeroid Engines / Importing Parts as kits
« on: January 24, 2006, 01:49:59 PM »
   Opinions please:
Would it or should it be cheaper to import these literoids as Kits in parts??My opinion is it should be cheaper?? ???

7
Listeroid Engines / PS Power salutions and Ashwamegh
« on: January 10, 2006, 07:58:41 PM »
   Are these two company's one and the same??

8
Listeroid Engines / Ashwamegh Information
« on: January 10, 2006, 01:46:32 PM »
   Does anyone know where I can get some info on these Listeroids?I am thinking about buying a 14-1 or a 15-1 and I would like to know what type of bearings and lurication they are using.Is there a websight?I could not find any info???

9
Listeroid Engines / Gen.head size
« on: January 09, 2006, 07:32:11 PM »
   Does anyone know how big of a gen head I can use on a 14-1 engine??

10
Listeroid Engines / Sizing units
« on: January 08, 2006, 01:37:11 PM »
  Hello All,
I am about ready to purchase a Gm-90 from a fella in the Carolinas,has anyone had any experiance with this machine?I am curious on how I should size this,what is the rule of thumb?I was told that it is usually two Hp per Killowatt is this so?I am planning on going off the grid on Vo with a combination of gen set and alternater charging a set of batteries and an inverter,any help here would be appriciated...Thanks in advance Ralph

Pages: [1]