1
Engines / Re: need help with my lister d type
« on: May 26, 2009, 10:22:40 PM »
who els should i ask then 
??
??
Home of the Listeroid - Since 2005
News:
Don't forget to check out the LEF Gallery! Exclusively for LEF members, an ideal alternative to Photobucket, Flickr, etc. It's FREE, and best of all totally AD FREE! Just click the link!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Engines / need help with my lister d type
« on: May 26, 2009, 07:00:08 PM »
over the last 2 weeks i have stripped it down fully checked over my lister d type and found that the big end had gone so I have got a new bush for it. it is a Phosphor Bronze bush are they any good
Secondly before I restored it. It was smoking quite a bit this seemed to start when I toped the oil up I dident over fill it I just put enough in to fill it to the oil here level the oil I used was 20w50 motor oil what should I use in it (there is little or no wear in the piston and rings and bore) so I don’t think it could be that
finaly before I restored it. It run ok it would tick over good but it would sometimes cough and splutter and backfire threw the carb I have re seated the valves and cleaned all the muc out of it will this help
thanks sam
Secondly before I restored it. It was smoking quite a bit this seemed to start when I toped the oil up I dident over fill it I just put enough in to fill it to the oil here level the oil I used was 20w50 motor oil what should I use in it (there is little or no wear in the piston and rings and bore) so I don’t think it could be that
finaly before I restored it. It run ok it would tick over good but it would sometimes cough and splutter and backfire threw the carb I have re seated the valves and cleaned all the muc out of it will this help
thanks sam
3
Engines / what are the chansies of snapping of one of my lister d cilinder head bolts
« on: November 01, 2008, 11:00:28 PM »
4
Engines / what are the outside and inside mesurments of the of a lister d starting handle
« on: October 12, 2008, 08:15:23 PM »
just need to know in mm plz
5
Engines / Re: converting a lister from air cooled to water cooled
« on: October 11, 2008, 09:08:20 PM »
what you could do is get copper brake pipe of a car and wrap it around the cooling fins dont no it may work could also get a pump on it
6
Listeroid Engines / Re: how do i set the timeing on my lister d
« on: October 11, 2008, 10:54:58 AM »
sorry about posting here ime new lol
thanks fore the advice
thanks fore the advice
7
Engines / how do i set the timeing on my lister d
« on: October 10, 2008, 11:27:34 PM »
i am not sure how to do it
can eneyone help
can eneyone help
8
Listeroid Engines / how do i set the timeing on my lister d
« on: October 10, 2008, 11:10:51 PM »
need some help not sure how
9
Listeroid Engines / Re: Made a propane tank muffler today
« on: October 09, 2008, 04:35:52 PM »
they seem to work so well i think i will go make one
make sure there is mo gas in it lol
make sure there is mo gas in it lol
Pages: [1]