Puppeteer

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lendusaquid

Pages: 1 ... 20 21 [22]
316
Original Lister Cs Engines / Re: Slightly Unusual 5/1 Lister
« on: November 04, 2006, 05:30:14 PM »
My piston must have been changed as i have 4 1/8 rings abouve the pin.Its looks like i will have to change the bottom one to a oil scrapper ring.Thats if i can find one.

317
Original Lister Cs Engines / Re: Finding parts to restore a 3/1
« on: November 03, 2006, 09:55:24 PM »
I have just purchased 4 valves from e-bay.2 for a 3/1 and 2 for a 5/1.The 3/1 valves are of no use to me so i was going to put them back on e-bay.So if you want let me know.

318
Original Lister Cs Engines / Re: Slightly Unusual 5/1 Lister
« on: November 03, 2006, 09:48:18 PM »
Thanks for the info, and your right about the splash plate because there is no bolt for fixing it to the back of the crankcase.And also ill just mention that the piston only has 4 rings and no place for a oil scrapper ring.

319
Original Lister Cs Engines / Re: Slightly Unusual 5/1 Lister
« on: November 01, 2006, 10:00:18 PM »
Sorry to get of subject but you mentioned rotation.This is something i am having a spot off bother with.I have a 1933 lister cs 5/1 serial No 3044 and i dont know which way it runs.I got it with the handle wanting to crank anti clockwise and the dipper is facing the door.It also looks to be a scoop dipper which surely must be wrong?.How can i tell for sure which way it is ment to run?.Cranking from the pump side by the way.

320
Original Lister Cs Engines / Re: Original CS Lister What's it worth?
« on: October 05, 2006, 10:46:10 PM »
Well after removing various stuck and rusty bits the engine now turns over.The exhaust valve was preventing the piston reaching tdc.Now in the process of dismantling the pump and getting that unstuck

321
Original Lister Cs Engines / Re: Original CS Lister What's it worth?
« on: September 26, 2006, 09:01:41 PM »
Hello people
This is my first post of many no dought.
I have just purchased a lister for £100 off the net(not e-bay).Needs shed loads of work.
On the plate it has got this
CS3044  spec 5/1/17
HP 5  RPM 600
When i start stripping it ill soon know if its a bargain or not.At the moment it turns over some of the way and then jams.

Pages: 1 ... 20 21 [22]