Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bent Trigger

Pages: [1] 2 3 ... 12
1
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: June 06, 2026, 11:58:43 PM »
https://photos.app.goo.gl/fAaGvAc5DGcpk6g4A

Finally getting back to  the Last of this. I Hope!
Life is flinging towards the future!
I have to add a couple Mount to the rear of this Frame for the Radiator and there will be a Jack Shaft in the back to spin the RPM magneto. And the batteries will be above the Generator. Not the best position but will work for Me!
I did it like this so nothing would be on the original bed, although the fuel tank will be on a board under the inboard Generator Bearing.
Thanks For Watching!
Chris

2
Sorry I can't help you with what you're looking for information-wise but pictures help a lot if you think it's magnetism and slap a couple of magnets on the outside of it the bigger the magnet the better start it and see if anything pops up on the voltmeters Good luck
Happy New Year

3
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: December 25, 2025, 04:53:52 AM »
Merry Christmas to All!!
May God Bless You In All Your Ventures!!

4
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: December 22, 2025, 02:23:56 AM »
So I have been working on other projects and will soon be attempting to get a control panel together to finish this project. I cannot find an original control so I will be doing my best to make something that will hopefully be a reasonable facsimile. It will certainly not be as Elegant as the Original!!
See Ya in the Spring!
And
Merry Christmas!!
https://photos.app.goo.gl/bj3GTW4aPSgzjWKE6

7
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 30, 2025, 11:42:19 AM »
https://photos.app.goo.gl/H9yCu7tcRLrsj39a9
Working on the speedo
I calculated it to 100-1
So I bought a cheap Chinese 3 planetary reducer
Hope it works until I find something ancient.
Keith I'll get a clearer Pic of that bender MFG Sorry.
[/quote
I said 100-1- should be 25-1 or there abouts 
I must have been thinking of my 1800rpm gens dang!!

8
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 21, 2025, 08:50:34 PM »
https://photos.app.goo.gl/kEWzAezHqxRkds6T6
Hey go Keith it's a holesclaw who knew I got a bigger one too

9
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 21, 2025, 12:44:29 PM »
https://photos.app.goo.gl/H9yCu7tcRLrsj39a9
Working on the speedo
I calculated it to 100-1
So I bought a cheap Chinese 3 planetary reducer
Hope it works until I find something ancient.
Keith I'll get a clearer Pic of that bender MFG Sorry.

10
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 20, 2025, 11:02:16 PM »
Here ya go Keith
I got it at a garage sale a long time ago and this is my first use of it  worked great.
https://photos.app.goo.gl/s2eH5CVdeMu1aVts9

11
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 14, 2025, 10:58:21 PM »
Oil filter working
Had to prime the system
Making voltage
Need to add an muffler
https://photos.app.goo.gl/q13BND8rr93Cj57v5

14
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: September 05, 2025, 01:48:38 AM »
https://photos.app.goo.gl/WyVUxUh3zxWSAQ5PA
Finally got the Oil Filter Bracket Made

15
Lister Based Generators / Re: 1925 Lister 2T and Generator
« on: August 30, 2025, 11:17:08 PM »
Cleaned up the pcs and shortened the snoot as I thought it might be bottoming out in the elbow.then blasted and jb weld both pcs liberally. And back in the vice for a 48hr cure.
When i clean it back up I'll add a couple tint screws to help hold it forever. Got to get this finished  to run the engine!!

Pages: [1] 2 3 ... 12