Puppeteer

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - magneto man

Pages: [1]
1
Petteroids / avaiability of Petter m head studs
« on: May 22, 2020, 09:47:01 AM »
Anyone know of a possible source of head studs for an M type appletop engine, also big end bolts?
A further question:- the head bolts protrude into the cooling water in the appletop and have brass nuts, but obviously in the case of the engine we are rebuilding the water has damaged the studs, as the top of the brass nuts is open! Is there normally some sealing plug or similar, fitting into the top of the nut to prevent such corrosion?

Thank you in anticipation

MM

2
Everything else / Air Motor Starters
« on: May 21, 2020, 07:54:45 AM »
Has anyone got experience of using an airmotor to start various old single cylinder engines? I have seen a device being used to start F1 cars by shoving it into the engine rear, then applying air the detaching the device. Some thing like this would be great for firing up these engines as one get older, and finds turning them over getting more and more difficult.  It would need to be detachable so that it covered various engines.
What would be a likely HP and torque requirement say to start a Lister CS. As the compression can be removed there should not be too much load initially!
Any comments? cheers

3
Petteroids / PETTERS UNIVERSAL "M" TYPE new model ENGINE
« on: May 17, 2020, 10:25:56 AM »
Hi, Does anyone have a drawing or information on the governor setup on an M type Petters? Trying to reassemble an engine and have no information as to how the governor is reassembled.
Any help appreciated.

Thank you

MM

4
Petteroids / PETTERS UNIVERSAL "M" TYPE OIL ENGINE
« on: December 11, 2019, 03:16:27 AM »
Just in receipt of the above engine which states on the name plate NEW MODELNo 11636 , 1 1/2 BHP @ 750 RPM . Does anyone have any information on this type of engine ? Also any information on its operation ? It has quite a different carby and fuel set up in general and not sure how to go about rebuilding it. Ideally a  manual would assist ! Where would one obtain same?
This model was apparently known as an Appletop, because of the cooling water tank on top of the cylinder which was spherical.

5
Lister Based Generators / Lister engines
« on: December 07, 2019, 10:14:57 AM »
We are about to commence rebuilding a Lister engine  which has the name plate details as follows:-

Type 2L  Spec 75L HP5  RPM 450 Ser No 38373

Can anyone give some information regarding build date and availability of parts, rings etc.

Thank you

George

Pages: [1]