Show Posts
1
Original Lister Cs Engines / Start-o-Matic baseplate - thread type?
« on: July 15, 2019, 07:23:29 PM »
Hello Everybody
I bought an early '50s (I think) 6/1 a few months ago, which at some point used to be most of a S-O-M. All the generator bits are gone though now.
I've had it running but would quite like to make it do some work, probably some form of generator.
It is mounted on a cast iron base plate - there is a machined flat section and four holes where the alternator would have sat. Please could somebody tell me what thread size these holes are? They're not 1/2" BSW or 1/2"BSF.
Many thanks,
Matt
I bought an early '50s (I think) 6/1 a few months ago, which at some point used to be most of a S-O-M. All the generator bits are gone though now.
I've had it running but would quite like to make it do some work, probably some form of generator.
It is mounted on a cast iron base plate - there is a machined flat section and four holes where the alternator would have sat. Please could somebody tell me what thread size these holes are? They're not 1/2" BSW or 1/2"BSF.
Many thanks,
Matt