Puppeteer

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Blue

Pages: 1 [2]
16
Engines / Lister HR
« on: June 17, 2012, 05:00:29 PM »
I have a chance of a HR3 with a 24.1 kw (3 phase) Stamford generator on it. I don't see much written about this series here. Are they O.K.? It looks like an overgrown ST to me as it has a 4.25" bore rather than 3.75". Suppose they had the same fuel leak problems as the ST's. It was a standby generator so has few hours.

Blue

17
Engines / ST cylinder heads
« on: April 21, 2012, 08:07:02 PM »
I am rebuilding an ST2 which is connected to a 220v.d.c. welder turning @ 3,000 rpm. I just ground in the valves and looking in the parts book I have it shows a seal and large washer under the inlet valve spring. On my head there is no machined area for an o ring to fit down into on the inlet side BUT there is an obvious place machined into the head on the exhaust side. Whichever way the large flat washers are missing. Anyone know anything about this, would be pleased to hear.

Pages: 1 [2]