Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - markymark

Pages: [1]
1
Changfa Engines / Re: Changfa Zs1115Gm fuel filter assy change
« on: December 11, 2022, 03:36:36 PM »
Thank you for the  info sir
much appreciated

have a great day..

2
Changfa Engines / Changfa ZS1115GPM build date 2005 engine number 605100040
« on: December 10, 2022, 02:31:27 PM »
Should the  fuel from the   fuel  tank,   be  running freely  thru  primary  filter in the  tank. If  fuel valve from  tank to the  fuel filter is in  the open  position ?
Or does the  pump suck and create  pressure  to the  injector

thanks .

3
Changfa Engines / Changfa Zs1115Gm fuel filter assy change
« on: December 10, 2022, 01:36:23 AM »
hello

when the tank runs dry
or filter change    do we have to bleed the  injector.
Im sure we do
but no bleeder on  injector housing .so im guessing  crack a line open?
which  one

thanks.
Mark.

4
hello
when the tank runs dry
or filter change    do we have to bleed the  injector.
and if so
best  way by  injector feed or  return

thank s.

5
Welcome to the LEF. Information and parts is pretty sparse here in the states. I have the fuel filter in stock that fits most of them. Masters Farm Supply in Fla. has a few parts. https://mastersfarmsupply.com/. Each engine was delivered with a spare parts kit and manual, see if you can find them.

 You can get anything you need through Alibaba.
Other than an operators manual there is little how-to literature that I am aware of. If it has been sitting a while it is possible that the pump and/or injector will be stuck.
Without writing a book about it the basics are this.
 To start it you will find a lever on the valve cover that is the compression release, ooen the throttle an bit. Spin it over and while spinning throw off the compression release and it starts. If not yoy either have compression problems or fuel delivery problems.

Thank you for info  guys            Got  it  started
my next step is  to  see is the  generator  side is ok     Found a  Mouse   condo  inside

6
Welcome to the LEF. Information and parts is pretty sparse here in the states. I have the fuel filter in stock that fits most of them. Masters Farm Supply in Fla. has a few parts. https://mastersfarmsupply.com/. Each engine was delivered with a spare parts kit and manual, see if you can find them.

 You can get anything you need through Alibaba.
Other than an operators manual there is little how-to literature that I am aware of. If it has been sitting a while it is possible that the pump and/or injector will be stuck.
Without writing a book about it the basics are this.
 To start it you will find a lever on the valve cover that is the compression release, ooen the throttle an bit. Spin it over and while spinning throw off the compression release and it starts. If not yoy either have compression problems or fuel delivery problems.

7
Changfa Engines / Changfa ZS1115GPM build date 2005 engine number 605100040
« on: November 12, 2022, 07:20:43 PM »
Hello guys  ,new to these forums

Have been asked to get this unit running  if  possible
estate    owner   states that  it  has  not run  much
It has electric start

Would like to get it going .
Would one of you fellows have a guideline that I can follow to get  her running
I have contacted Changfa  (China) for parts  (gas filter,oil filter)  but  not too much   info from them
Is there someone in Canada or USA  that has parts

thank you  for your time

Mark

Pages: [1]