Puppeteer

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Newbie00

Pages: [1]
1
Engines / Re: Lister d timing
« on: June 25, 2019, 07:17:31 AM »
Ok thanks guys I will have a look into it when I have some spare time 👍

2
Engines / Re: Lister d timing
« on: June 21, 2019, 03:31:31 PM »
Hi guys update it was the spark plug all along  :-[ I’ve managed to start it for about 30 seconds it was running very slow and I had to keep holding the air intake up for it to run again then it cut out so I took the spark plug out and it was completely black and loads of fuel on it so is it running too rich if so how do I prevent this cheers newbie

3
Engines / Re: Lister d timing
« on: June 20, 2019, 05:03:23 PM »
Ok I shall upload some photos soon it’s a Lucas r1 mag

4
Engines / Re: Lister d timing
« on: June 19, 2019, 05:02:17 PM »
Hi guys thanks so much for all your input I will try some of the things you have suggested after my plug arrives and keep you updated on what happens, thanks a lot newbie

5
Engines / Re: Lister d timing
« on: June 18, 2019, 09:20:48 PM »
Hi guys I think I know what the issue is I don’t have a very strong spark at all I’ve just ordered a new spark plug but I was wondering how to get a stronger spark I’ve cleaned all the points and the earth clamp is there anything else I can do many thanks newbie.

6
Engines / Re: Lister d timing
« on: June 18, 2019, 02:42:12 PM »
Hi guys thanks for getting back I meant to say that it has only every started the once then cut out but I’ve never been able to get it running since and I know it’s getting fuel because the spark plugs wet and I know it’s got a good spark because i can see it sparking this is why I’m really confused.
Thanks newbie

7
Engines / Lister d timing
« on: June 17, 2019, 08:27:33 PM »
Hi guys, I’m having a bit of an issue as I’m new to this which is why i want your guys help my lister d will run then cut out and not start anymore but do you think this is due to timing or would the engine not start at all. Many thanks newbie.

Pages: [1]