Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ron

Pages: [1]
1
Engines / Continuation on my first post on LV1 Cyl Heads removal
« on: February 23, 2019, 02:51:24 AM »
Still haven't got the heads off but have removed the Flywheel and Aluminum fan shroud. I am amazed to discover the pistons are not seized but rather a whole bunch of crap built up between the back of the flywheel and the crankcase.  engine rolls over easy - probably too easy. Thinking ahead to future problems, can I use a ridged hone to remove some of the excess tapper from these cylinder barrels? Assuming there is excess tapper. Then go back together with standard rings? Secondly, I'm in Northern Ontario Canada and are there recommendations as to a parts supplier?

Thanks again for any assistance. Ron

2
Engines / Re: Lister LV2 Cylinder heads removal
« on: November 08, 2018, 02:04:00 AM »
Thanks, winters commin' here so I'll have lots of time on my hands. I'll drag it into the kitchen an throw another block of birch on the fire.

3
Engines / Lister LV2 Cylinder heads removal
« on: November 08, 2018, 12:18:56 AM »
I have a Lister Petter LV2 that probably saw a lot of salt. I can't seem to lift the heads off the cylinders. Any suggestions?

Pages: [1]