Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - builder

Pages: [1]
Waste Motor Oil / waste motor oil to diesel
« on: April 28, 2012, 11:14:50 AM »

Original Lister Cs Engines / Re: paper gaskets
« on: July 28, 2010, 11:02:32 PM »
no its only the barrel water jacket inspection plates  ,the crank and breather cover plate,the flow and return cast iron threaded 1/1/4 pieces that bolts to the head,i wouldnt like to use silcone on the head, the copper one did the job, but the gasket set i did buy came with some of the pump seals ,and some i didnt even use

Original Lister Cs Engines / Re: paper gaskets
« on: July 28, 2010, 05:13:02 PM »
stationary engine parts york ltd, i dont now why i just didnt us modern tecnology in the first place when this engine was built they just didnt have this stuff in a tube at a fraction of the cost was advised at s/e/p that they used paper gaskets when made,but they would because thats all they had 

Original Lister Cs Engines / paper gaskets
« on: July 27, 2010, 11:56:02 PM »
just finished changing all paper gaskets fittered on cooling cistem on my cs 8/1 lister, after every one leaked from new a bit of advice dont use paper gaskets at all, i have used heat risistent silicon and not a drip that also goes for the crank case inspection plate which was driping oil a bit , not now with the same silicon.

Generators / Re: Lister.Brushes.
« on: September 02, 2009, 11:27:05 PM »
if you take the old brushes to a carbon brush company nearest to you they will test for the right copper content and hardness, measure from the top of the brass brush holder to the com then add a 1/4 of an inch that should allow enough for sanding to bed
cheers carl

Pages: [1]