Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sam37

Pages: [1]
1
Engines / need help with my lister d type
« on: May 26, 2009, 07:00:08 PM »
 over the last 2 weeks i have stripped it down fully checked over my lister d type and found that the big end had gone so I have got a new bush for it. it is a Phosphor Bronze bush are they any good

Secondly before I restored it. It was smoking quite a bit this seemed to start when I toped the oil up I dident over fill it I just put enough in to fill it to the oil here level the oil I used was 20w50 motor oil what should I use in it (there is little or no wear in the piston and rings and bore) so I don’t think it could be that

finaly before I restored it. It run ok it would tick over good but it would sometimes cough and splutter and backfire threw the carb I have re seated the valves and cleaned all the muc out of it will this help 

thanks sam

2
Engines / what are the chansies of snapping of one of my lister d cilinder head bolts
« on: November 01, 2008, 11:00:28 PM »
 ??? ???

3
Engines / what are the outside and inside mesurments of the of a lister d starting handle
« on: October 12, 2008, 08:15:23 PM »
just need to know in mm plz

4
Engines / how do i set the timeing on my lister d
« on: October 10, 2008, 11:27:34 PM »
i am not sure how to do it



can eneyone help ??? ??? ???

5
Listeroid Engines / how do i set the timeing on my lister d
« on: October 10, 2008, 11:10:51 PM »
need some help not sure how

Pages: [1]