1
Listeroid Engines / Cooling Water problem by a lovson 6/1
« on: September 27, 2006, 02:47:31 PM »
Hi i am testing my Lovson 6/1 until now i have what i expect after reading the forum here.
But during the first test i have a oops where is my water flow. it is to low what is this sand?
until this moment the engine is clean from sand.
So i take the cylinder heat off and there is only 4% from the opening in the cylinder heat if you but the packing on it, this is a big mold fault in every cooling channel.
no it is not sand it is 12mm metall blocking.
p.s. i have pictures but the inserting in this post is a not soved problem for me.
Thanks for any help
But during the first test i have a oops where is my water flow. it is to low what is this sand?
until this moment the engine is clean from sand.
So i take the cylinder heat off and there is only 4% from the opening in the cylinder heat if you but the packing on it, this is a big mold fault in every cooling channel.
no it is not sand it is 12mm metall blocking.
p.s. i have pictures but the inserting in this post is a not soved problem for me.
Thanks for any help