I just got in the house from talking with the local inspector and I have very few details to finish my Listeroid generator system with a battery/inverter on the side. It's a 6/1 Metro with a ST5 head and GM serpentine belt. My Reliance transfer switch and sub panel will be able to support most of the critical circuits in the new home we're building and the battery/inverter system will be used to run some light circuits and a few outlets. The only issues were a bonding screw in my main panel and the ground wire was not yet terminated in my generator's disconnect switch. I also must run a ground wire from my generator panel in the house to my inverter panel. Everything was researched and I tried my best to meet all of the NEC requirements, I just needed the inspector to show me the finishing touches to get it blessed. It's quite a load off my mind after 1 1/2 years of research and hard work. A lot of the info came from this board, thanks.