Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Barry T

Pages: [1]
1
Listeroid Engines / Re: Conrod
« on: May 02, 2020, 09:59:46 PM »
Hi
Got my jp1 running today with a replacement Conrod and new piston and liner,
Also the old liner had been fitted incorrectly previously and that is how the conrod has been bent,
Thanks all for you help.
Barry

2
Listeroid Engines / Re: Conrod
« on: May 02, 2020, 09:38:36 PM »
Hi
Got my jp1 running today with a replacement Conrod and new piston and liner,
Also the old liner had been fitted incorrectly previously and that is how the conrod has been bent,
Thanks all for you help.
Barry

3
Listeroid Engines / Re: Conrod
« on: April 16, 2020, 09:53:13 AM »
lister photos

4
Listeroid Engines / Re: Conrod
« on: April 14, 2020, 04:06:30 PM »
Yes Aluminum piston,
I don’t know the history on it but when I went to get it running I drained the oil, when cleaning the sump I found the lug belonging to the liner, When I turn the engine over the conrod is only clearing the liner,
Thanks
Barry

5
Listeroid Engines / Conrod
« on: April 13, 2020, 11:28:03 PM »
Hi
Has anyone straightened a conrod,
 I have a 9hp cs47020 9-1-35 which I bought a few years ago and with the lock down i pulled it out to get it running but it has very low compression, After pulling the head off the liner was dragged but honed out and I cleaned the piston with emery cloth, I have Re ground the valves but need either a conrod or straighten this one if possible.
Thanks
Barry

Pages: [1]