Puppeteer

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JETMECH10

Pages: [1]
1
Engines / Re: how adjust pushrods for GM90
« on: June 25, 2020, 02:08:20 AM »
thanks for your reply both of you. 
I did not have any problem until I was forced to remove lifters while moving rocker arms because they did not did not a line with the top of valves themselves.  After tightening down rocker arms the lifters required a excessive amount of adjustment.   But I have been able to compleat adjustment, and have engine running fine once more.  I have the lifter rods rotating by themselves once again

2
Engines / how adjust pushrods for GM90
« on: June 24, 2020, 12:05:58 AM »
Hello I have a Satyajeet GM 90 , 6 HP single cylinder engine that I inherited.  Its not that old and was taken apart to change head gasket.
I need correct info on proper toque on head bolts, and the order to toque bolts.  One of the push pull rods for the engine ( exhaust valve)
is way to short?  How can push pull rods be adjusted? 

Thanks for all you assistance and help.  From JETMECH10

Pages: [1]