bump ... still trying to work out this dam tank drain ..
 I belive the voltage regulator has been moved on this unit .somthing is just not right . what a well made gen set in all its drab green

woo dumpers I have three .. even one made in Australia !
Hope you are keeping dry

Hi all anyone got any leads on a manual for the 3 phase Generator ?
 Its all painted Army green !! It starts and runs Well . I need to sort out the Generator end . thanks Mark Canberra Australia

There is a great carburetor in an old oil heater take a look at them. . I used to service them . They have a float height control and an element to heat the oil .

Hi all I have seen a couple of fuel filter mods for the original Cast iron fuel filter .
 I want to know what fuel filter people are using . I can do the machining but cant find a suitable filter .
 My local filter place was a total waste of time . thanks to all

Hi all is Bob ok ? I have been trying to contact him . He has been in Hospital .

Hi all slowly getting it to bits .  It's looking much better .. but
I have found a loose crankshaft timing gear . I did not want to take out the crankshaft but it looks like it will have to come out to fix the timing gear I suspect it will have a worn out key . Not looking forward to getting it out . I only have one shoulder that works properly .  I am thinking of remove flywheel and putting it on it's end and pulling out the crankshaft with the forklift . It's big and ugly .  What do you think about this . 

Great job .  Just about put me to sleep