15
« on: October 13, 2021, 05:03:09 PM »
Hello Bruce,
I am not sure what part of the world you stay but there must be a time difference between us I am in the far north of the UK.
I am generating 220Volt 50 hz it is a old type BKB start o matic
Do you think that the photos I sent of the voltage cut out will work on the AC 220volt
I could get one for the 24 volt charging side and set it to trip at 28 volt (that's a guesstimate). you could please advise on the upper voltage trip setting.
the reason that I believe that the 220 volt side wont work as well is because I have one of that device that plugs into a socket then you plug in a load IE: light or heater into it. it has a screen that reads the voltage, amps, hertz . when the unit is plugged in on its own the engine dose not start. then the heater is switched on the engine starts when the heater is switched off but still plugged into the device the engine still runs until the device is switched off. if this makes sense. I only use this plug to test check the volts amps hertz
I am unable to run the engine over rev at the moment because when she over reved she brunt out the charging resistor. I have sent for 0.8mm wire to rewind the resistor.
Regards
John