Lister Engine Forum

Lister Engines => Listeroid Engines => Topic started by: Brad Silwood on November 02, 2021, 03:43:26 AM

Title: Pushrods
Post by: Brad Silwood on November 02, 2021, 03:43:26 AM

I was negligent in labeling, for different length pushrods. Which length goes on which side. Thanks guys

Title: Re: Pushrods
Post by: veggie on November 02, 2021, 02:06:27 PM

Strange, on my engine the push rods are the same length.

Title: Re: Pushrods
Post by: Brad Silwood on November 02, 2021, 08:23:28 PM

Thanks Veggie, yea, I "assumed" mine would have been also. One is 3/8 inch longer than the other.  :-\

Title: Re: Pushrods
Post by: 38ac on November 02, 2021, 11:50:38 PM

The long one goes on the intake valve. Look at the lifters, the exhaust lifter is taller due to the compression release.

Title: Re: Pushrods
Post by: mike90045 on November 03, 2021, 04:49:37 AM

I put a zip-tie on the far side ( exhaust ) pushrod, makes it easier to see it spinning around.  And mine are not the same length either.

Title: Re: Pushrods
Post by: Brad Silwood on November 03, 2021, 06:06:45 AM

Quote from: 38ac on November 02, 2021, 11:50:38 PM

The long one goes on the intake valve. Look at the lifters, the exhaust lifter is taller due to the compression release.

Yep, makes perfect sense. Thank you