Lister Engine Forum
Lister Engines => Original Lister Cs Engines => Topic started by: littleridge on October 09, 2020, 06:04:54 AM
-
Hello Members
What is the correct ring gap for new parts ,Rings and liner.
thanks.
-
It is not mentioned in the technical specifications but in my 6/1 manual the minimum end gap is .012". A 3/1 would be slightly less due to smaller bore. I would go with .010" Be sure to check the side gap in the top groove as they take a beating. restoring side gap is far more important than end gap as for restoring compression.
-
Thanks 38ac,I was on the same lines.