Lister Engine Forum
How to / DIY => Generators => Topic started by: 32 coupe on September 21, 2015, 10:07:46 PM
-
I did a cleanup, sprayed well with the red "varnish", new bearing
and added wood and epoxy shims to the loose bobbin.
I get just a little imbalance growl when the load gets up to about
10 to 12 amps on one side.....man, I'm happy with that !
This unit came with the AVR and "modern" rectifier. Whoa, almost
forgot the DIGITAL volt/frequency meter. What will those Indians
think of next ??
Just though you guys might like an update.
Carry on,
Gary
-
Thanks for the thread Gary. I have wondered if the growl in my 7.5 was caused by a slightly loose winding and you have seemed to confirm my suspicion. I will pull mine apart before I run it much more. It just doesn't seem right that it would make this noise just from the magnetic flux, something with mass is moving slightly :-\ .