Lister Engine Forum
Lister Engines => Petteroids => Topic started by: buickanddeere on May 08, 2009, 03:37:00 PM
-
PD series Petter engines air cooled, with 3-1/2" bore and 4-1/3" stroke. Anybody seen one?
When looking through the Petter specs. Many share the common 4-1/3" stroke. Noting that the PH use a 3-7/16 bore and the PJ has a much larger 3-13/16 bore. With the PD being a little larger than the PH with 3-1/2".
The line of thinking is.........When in there anyways and boring. The PH sleeve while being thick walled won't take a 3-13/16" bore up from the 3-7/16". There is however plenty of sleeve wall thickness left if bored 3-1/2" and a PD piston used.
Any ideas if the PD engines shared the same piston pin and deck height as the AV,PH & PJ engines? Odds are they do as commonality reduces production costs.
I wish I could have found a PJ1W engine but the PH1W is all I have to work with. The generator project leaves the factory PH1W a couple of HP short. I'm hoping a little tuning and mild tinkering by cleaning up the ports and a little more displacement. This engine would be able to make 10+HP at 1800rpm without excessive smoke.
Of interest the PD engine with the 3-1/2" bore makes as much power as the PJ engines with the 3-13/16" bore? The PD is only 1/8" more bore than the 8HP PH series?
Did the PD engines have better flowing cylinder heads or where did the extra HP come from?
-
Without seeing the specs on the PD my first thougt is the PD might be rated at 1800 rpm VS the 1500 of the PH
-
There's the big PDV, but they don't appear to have made a small single or twin cylinder version in that bore/stroke range.
That's got larger bore & stroke though.
http://www.stationary-engine.co.uk/PetterData/PetterPDV1.htm
There were a few PD's made, but 1956 or so, and not an engine that seems to crop up much at all these days.
http://www.stationary-engine.co.uk/PetterData/petter2.htm
Peter