Puppeteer

Author Topic: engine stand TL2 motor  (Read 107 times)

chefiam1

  • Newbie
  • *
  • Posts: 10
    • View Profile
engine stand TL2 motor
« on: October 05, 2019, 02:27:35 PM »
do you use the bolt holes on the flywheel casing to mount the engine?
or is there another way. you can tell im a newbie.

                                              thanks, chefiam

cobbadog

  • Full Member
  • ***
  • Posts: 226
    • View Profile
Re: engine stand TL2 motor
« Reply #1 on: October 06, 2019, 05:33:26 AM »
G'Day chefiam,
there is no shame in asking questions when unsure or we simply do not know, so ask as many questions as needed. To answer your question this time I would need to see a picture of the area that you are talking about.
Coopernook - the centre of our Universe.

mikenash

  • Hero Member
  • *****
  • Posts: 674
    • View Profile
Re: engine stand TL2 motor
« Reply #2 on: October 06, 2019, 07:09:33 AM »
Hi Chef

If you're thinking of the hole around the outside/perimeter of the casing?  More likely they are used to retain something driven by the output shaft there - gearbox etc? . . .

Most likely the engine will have four cast-in feet with bolt holes?

Good luck

sirpedrosa

  • Sr. Member
  • ****
  • Posts: 369
  • Just one more day hoping to hear that sound
    • View Profile
Re: engine stand TL2 motor
« Reply #3 on: October 06, 2019, 03:44:12 PM »
Hi Chefiam

I'm in too. place a pic - I mean as much as you can - and after we'll give any assystance you need.

"first things first". Am I wrigth?

Cheers
VP
Bernard 18A - 1968 (mama's water pump - year of my birth)
Petter PAZ1 - Jun 1967, 3HP, sn 416xxxx
Petter PAZ1 - Nov 1979, 3HP, sn 425xxxx