G`Day Gentlemen and Women,
I am sorry I have stalled on my rebuild but doctors(and Wife`s) orders are not to be messed with. Stupid bugger decided not to treat the disk in my neck that is pressing on my spinal cord causing pain in hands and arms, instead he tried to treat the symptoms with Lyrica. For those who have never experienced this drug, it is used to treat epilepsy and nerve pain. You start with a dose of 25Mg per day and work up to 600Mg per day. It is addictive and causes mental instability, suicide and heart failure, it is a treatment of last resort. At a dose of 600Mg it is going to cost $50 per day. I wish I had a video of the look on my doctors face when I pointed out to him that I have already had one heart attack and am seeing a councillor for mental health issues and would rather have the pain than become a zombie.
So back to my build, I have decided that this CS will be coupled to a three phase head to provide power for a lathe and milling machine. I will have to build it a brick enclosure next to my ST2. When I built the enclosure for the ST2 I dug out a deep hole and poured a concrete slab at the bottom, I then used a 100Ltr plastic dustbin as a former and poured a reinforced concrete chamber. This was connected to 8 meters of 3" underground flexible ducting(also set in concrete) which runs down hill to an exhaust. I later cast a concrete slab over this chamber and my ST2 vents into it. (see photo) It is totally silent.
My question is this: would it be ok to rig the CS to vent into the same exhaust system or should I build a separate underground exhaust?
Bob