Puppeteer

Author Topic: New member with HA3  (Read 6783 times)

Perri

  • Newbie
  • *
  • Posts: 6
    • View Profile
New member with HA3
« on: March 28, 2015, 04:46:41 PM »
New member here, have well read this forum. I have a Lister HA3 with low hours, <500hrs. estimated. It does however have a cracked #1 cylinder barrel from top to bottom. Notwithstanding, it runs very well, just blowing smoke and oil around that cracked cylinder.
I intend to put this in a 28' boat, therefore I won't need the Capitol model EFR8900 Rev. & Red. 3.047 To 1 gear that's attached to the Lister. Hopefully, I can attach a 1 To 1 Velvet Drive to this engine without a lot of adaptation?
I'm aware of the many key players on this forum, so I'm confident I will get help and advise from you kind people.

Here's what I need,

Source for a used HA cylinder barrel, I know new ones are available in KS. and may be my only option, but I'd like to see if I could get a used one first.
I will post what I want to buy over there, just wanted to say hello on my first post.
Thanks everyone

 

Perri

  • Newbie
  • *
  • Posts: 6
    • View Profile
Re: New member with HA3
« Reply #1 on: April 09, 2015, 01:26:37 AM »
Anyone with a HA3 cylinder barrel, Trying to limit expenses.