Puppeteer
« previous next »
Pages: [1]

Author Topic: 6/1 starting pawl, or latch  (Read 3575 times)

38ac

  • Hero Member
  • *****
  • Posts: 2327
    • View Profile
6/1 starting pawl, or latch
« on: March 21, 2011, 01:16:55 PM »
R
« Last Edit: August 31, 2019, 01:42:11 PM by 38ac »
Logged
Collector and horder of about anything diesel

Tom

  • Hero Member
  • *****
  • Posts: 1746
  • Green power is good.
    • View Profile
Re: 6/1 starting pawl, or latch
« Reply #1 on: March 21, 2011, 05:49:52 PM »
That looks like there will not be nearly enough rack travel. Can the pawl be turned so the flat portion strikes the body of the IP? Looks like it flipped over and placed on the outside of the rack.
Logged
Tom
2004 Ashwamegh 6/1 #217 - ST5 just over 3k hours.

Bottleveg

  • Full Member
  • ***
  • Posts: 246
    • View Profile
Re: 6/1 starting pawl, or latch
« Reply #2 on: March 21, 2011, 07:53:22 PM »
It goes with the rounded part furthest from the pump and the stud under the shaft.
To start the engine; lift the rounded part up to allow more travel of the fuel rack. On starting the pawl drops down and limits the travel.
Logged

Bottleveg

  • Full Member
  • ***
  • Posts: 246
    • View Profile
Re: 6/1 starting pawl, or latch
« Reply #3 on: March 21, 2011, 08:18:19 PM »

Logged

38ac

  • Hero Member
  • *****
  • Posts: 2327
    • View Profile
Re: 6/1 starting pawl, or latch
« Reply #4 on: March 22, 2011, 01:16:13 AM »
thank you! we now have it correctly installed.

Butch
Logged
Collector and horder of about anything diesel
Pages: [1]
« previous next »