HELP, Please!
I have an LD 1 with generator attached.
Engine number = 718LD16
Generator number = 12130/232
It is rated to output 1.5 KVA, 230volts, 50 cycles, at 1500rpm.
Was running and powering things fine. Whilst running a small chop saw which it has done countless times before, the saw jammed, the lights went out.
Now it is only putting out enough power to light the indicator light in the battery charger.
I have taken a look in the control box and all seemed fine. As we have had previous problems with the power lead, I have replaced that ... no change.
Sods law - the multimeter got dropped so can't give any readings until I replace that.
Any ideas as to what part has been upset, where to start with fault finding, how to get it back to chucking out decent amounts of power?

My LD 1 has a solenoid fitted to work as an remote stop. It attaches to the start, stop, on the side. My question is what sort if signal does it need? 12volt, 240volt?
It has a three core cable coming out of it.
Any help gratefully received.